Our ATS provides a stable power and a user-centred safety as well as the reliability and safety based on the quality and intensive technology that are recognized even by UL.
Our Auto Transfer Switch is designed and produced by applying a new IT
technology and it provides an optimal solution that is suitable in any customer’s
environment. It is a premium product equipped with a user-friendly protection function in order to satisfy diverse needs of customers and to ensure the safety.
High transfer performance for inductive load current
It is designed according to the recommended practice for emergency and standby power systems IEEE 446 , Independently tested and complying to ATS standards IEC 60947-6-1 (2005) ,and Available in Direct or Delay transfer to suit wide range of power transfer requirement
Specification
2 pole to 4 pole. 60A to 6300A
Advance programmable microprocessor controller
Miniature to Uninterruptible and High-pressure vacuum
From transfer to breaking, retain nations maximum full series
latch structure gives stable current transfer
Block spring method provides stable Open
Certified by ISO 9000 and suitable for UL. Exported to the U.S
Generating motor load transform
Saving power : It is in an instantaneous excitation mode with little operating.(1.6A in case of AC 220V operation)
Safe Design : The breaking part is molded for a dust-proof so the operational cycle of the contact
part is semi-permanent.
2-Coil Mode : It adopted a simple operation mode using 2 coils.
Miniature : It can be built inside the portable generator or UPS.
Low Cost : It is a miniature type and optimal for a single phase with less than 200A (non inductive)
Standard : IEC 60947-6-1 / UL1008
OUR NEW DEVELOPED ATS CONTROLLER
Our New ATS Controller provides TRANSFER time from Zero (0) Sec. Up to 30 Sec. and can use from UPS up to General Products.
High transfer performance designed according to the recommended practice for emergency and standby power systems IEEE 446 , Independently tested and complying to ATS standards IEC 60947-6-1 (2005).
1 AUTO/MANU button AUTO/MANUAL MODE Select Switch
2 TIMER(SEC) When Automatic transfer from EMER. To KEPCO. Adjust the time.(0~30sec)
3 TIMER LAMP Display lamp flicker during transfer operation flicker (KEPCO& Emer.)
4 POWER Display the power supply of KEPCO. side
5 MANUAL LAMP LAMP indicating that ATS MODE is set to MANUAL
6 AUTO LAMP LAMP indicating that the ATS transfer mode is set to AUTO
7 EMER. POWER Display the Power Supply of Emergency side.
9 TIMER(SEC) When automatic transfer from KEPCO. to EMER. Adjust the time(0~30sc)
10 KEPCO Manual Operation button Close to KEPCO. side manually.
(Do not operate while supply the power)
11 EMER Manual Operation button Close to Emergency side manually.
(Do not operate while supply the power)
Rating:
Model: ATS 02
System Voltage AC220V
Rated Frequency 50Hz , 60Hz,
Transfer Burden 3VA (AC)
Insulation 1.5kV/1Min.
Ambient Temperature -20 ~ 60 ℃
Size 120 * 120 * 84 mm
Weight 500g (0.5kG)